THE SIMPLE THREE STEP PROCESS WHICH SAVES TIME AND MONEY WHILE CREATING SAFER AND SUSTAINABLE SURFACES AND SUBSTRATES.
Strip wax then clean floor with Mineral Armor™ Surface Prep. Collect slurry with extractor or auto-scrubber.
Apply Mineral Armor™ Rejuvenator and burnish floor, honing to desired gloss. Pick up slurry with extractor or auto-scrubber and allow floor to dry.
Apply three coats of Mineral Armor™ Protector to floor with a microfiber flat mop. Allow 15 minutes of dry time between coats.
Never strip your floors again when using Mineral Armor™
Once Mineral Armor is applied, floors never need to be stripped and waxed again. All that is required is a simple three-step reapplication to rejuvenate and protect your floor's gloss and protective layer.
Floors stay cleaner with Mineral Armor™
Mineral Armor particles create a more hydrophilic, or water loving, surface, so dirt is repelled. This reduces soiling and the need for deep scrubbing.
These particles also significantly improve substrate’s protective hardness which improves abrasion, scratch, and corrosion resistance on surfaces and substrates.
Floors coated with Mineral Armor™ are less slippery.
Mineral Armor contains a Dynamic Coefficient of Friction (DCOF) 52-76% greater than the minimum DCOF. Particles in Mineral Armor increase the surface roughness and thus increase slip resistance. No VOCs are present in Mineral Armor’s high pH solution, so it is safe to use in all facilities without risk of contamination.
Floors coated with Mineral Armor™ require less maintenance.
Mineral Armor eliminates the need for stripping and waxing which decreases the amount of water used by 50% and decreases the use of electricity.
Mineral Armor’s high pH inhibits the growth of bacteria and allows for a safer and cleaner environment.
Mineral Armor has achieved a UL 410 anti-slip coating certification from UL Solutions. This helps to demonstrate our scientific approach to confirming the slip resistance of Mineral Armor. Learn more.